Chrysler, Jeep and Dodge Key Fob Programming by Dorman Products

Chrysler, Jeep and Dodge Key Fob Programming by Dorman Products


Welcome to Dorman Products Chrysler, Jeep, Dodge key fob installation video. This installation is considered simple, no car knowledge is needed. Suggested time of installation, is 5 minutes. Note: All key fobs must be present and reprogrammed when programming new fobs. To begin the installation, turn the vehicle ignition key to the on position without starting the engine. Insert programmer into OBD2 DLC port, located under the steering column near pedals. Press the lock and unlock buttons on the key fob simultaneously for 3 seconds. Then, press the unlock button for 2 seconds. Repeat this step for all additional remotes. Once all key fobs have been programmed, turn ignition key off and remove programmer from the OBD DLC port. Wait 2 minutes and verify each key fob functions properly. If programming was unsuccessful, restart the procedure.

9 thoughts on “Chrysler, Jeep and Dodge Key Fob Programming by Dorman Products”

  1. I needed the 13378 and can't buy it anywhere. Asked dorman and they said I don't know when it's going to be in its on back order?

  2. Jeep Liberty 2002 , ordered #13776 . Used my key only and programmed the fob that came with it ($53) along with 2 others I bought for $14. Worked perfectly in about 10 minutes. No dealer needed and saved a ton. Many Thanks Dorman !

Leave a Reply

Your email address will not be published. Required fields are marked *