HomeLink-Homelink programming for 2019 Jeep Cherokee


[Music] your vehicle may be equipped with our convenient home link system home link replaces up to three remote controls or handheld transmitters so you can operate devices such as garage door openers motorized gates lighting or home security systems from the safety of your driver’s seat you’ll find the home link buttons in the overhead console or on the Sun Visor to start programming for a garage door opener first make sure you’re parked outside the garage it’s also recommended that you put new batteries in the handheld device you’ll be programming the home link unit is powered by the vehicle’s battery and does not require replacement then you’ll want to reset the home link system memory to do this simply push and hold the two outside buttons until the indicator light flashes this could take up to 20 seconds this procedure erases all three home link button programs so you only need to do it once do not erase all three channels when programming additional buttons now before you program your home link system you’ll need to determine the type of garage door opener you have go to the garage door opener motor in the garage see if you can find the learn or train button which is usually found where the hanging antenna wire connects to the garage door opener motor it is not the same button normally used to open and close the door and it may vary by name or color depending on the manufacturer if you can find a learn or train button on the opener motor then you’re using a newer rolling code garage door opener and programming will involve a few additional steps if there is no learn or train button that means you have an older non-rolling code garage door opener once you know what type of opener you’re using you’re now ready to program the home link system here we go put the ignition switch in the on run position but don’t start the engine hold the handheld transmitter one two three inches or three to eight centimeters away from your home link system now simultaneously push and hold both the home link button you want to program and the handheld transmitter button watch the home link indicator light it will flash slowly at first and then rapidly it may take 30 seconds or more for the rapid flashing to occur when it does release both buttons the garage door may open and close while you’re programming to check your programming push and hold the just programmed home link button and observe the indicator light if the indicator light stays on continuously then programming is complete and the garage door should activate when the home link button is pushed at this point if you have an older non-rolling code garage door opener you’re done your home link controls and garage door opener should now be in sync if you have a rolling code garage door opener here’s where those additional steps come into play go to the garage door opener and once again find the learn or train button firmly push and release it you now have 30 seconds to return to the home link system so move quickly better yet it might be good to have a second person standing by at the home link system once there push the home link button you’d like to program twice hold the button for two seconds each time if the opener is plugged in and activates programming is complete if it does not activate push the button a third time for two seconds to complete the training please note that home link will be disabled any time an onboard security alarm is active if you have any problems or require assistance please call toll-free [Music]

Leave a Reply

Your email address will not be published. Required fields are marked *