The Solution to DIYMORE UNO Clone Error “stk500_recv() programmer is not responding”


In the name of Allah, the Entirely Merciful, the Especially Merciful. There is a problem in some Arduino UNO Clones like this DiyMore UNO Board The Problem is when you Click on upload the code, The RX Led Blinks Three Times And then uploading the Code takes a long time
and then it Gives you an Error which is: stk500_recv() programmer is not responding to resolve this problem Click on ‘Tools’ Then Click on ‘Board’ and then choose the third board which is, “Arduino Duemilanove or Diecimila” and Then Upload the code and the code should upload successfully and if you have an Arduino Nano from RobotDyne Brand Then the solution is to go to the Processor Tab
and change it Because it uses the old version of the Bootloader and Thanks for watching!

Leave a Reply

Your email address will not be published. Required fields are marked *